Microstructure and mechanical behavior of UFG copper processed by ECAP following different processing regimes

Commercially pure (99.9%) copper was severe plastically deformed by equal-channel angular pressing (ECAP) following route-Bc in three different processing regimes in order to obtain ultrafine-grained (UFG) microstructures leading to improved mechanical properties. In regime-1, the billets were processed at room temperature up to eight passes. The billets were processed at 200 degrees C up to eight passes in regime-2. Regime-3 is a hybrid regime by which the billets were deformed at 200 degrees C up to four passes first, and these billets were then processed at room temperature for one, two and four passes. In all regimes, the ECAP processing results in a refinement of the conventionally grained (CG) initial microstructure of copper down to sub-micron level leading to a great improvement in the strength as compared to CG copper. Among the regimes applied, regime-3 was found to be the best regime for improvement in strength along with adequate ductility. The samples showed more than eight times increases in yield strength after processing in regime-3 for 4 + 4 passes, from 47 MPa for CG copper to about 408 MPa for the UFG sample. Such improvement in strength was accompanied by a 16.9% total elongation and 6% uniform elongation. The processing in regime-2 resulted in the best elongation to failure of about 22% after eight passes, but it gave the lowest strength values among others.