Deformation behavior and formability of friction stir processed DP600 steel

The effect of friction stir processing (FSP) on the formability of DP600 steel was experimentally investigated and the basic relationships between biaxial deformation behavior and FSP-induced evolutions in microstructural and mechanical properties were established. FSP formed a microstructure that consists of lath martensite with increased volume fraction compared to as-received (AR) microstructure that mainly consisted of well-distributed fine martensite particles in a ferrite matrix. Consequently, AR yield strength (301 MPa) and ultimate tensile strength (621 MPa) increased to about 811 and 1054 MPa, respectively. This strength enhancement achieved accompanied by adequate uniform elongation and elongation to failure values of 6.3 and 13.0%, respectively. Under biaxial loading conditions, good strain hardenability of the AR DP600 steel brought about a large membrane stretching regime leading to high punch force for biaxial flow. After FSP, both punch displacements within the membrane stretching regime decreased due to the increased volume fraction of lath martensite leading to higher cracking tendency. In result, cup depth and peak punch force of FSPed DP600 decreased from 8.7 mm and 33.2 kN to 7.1 mm and 28.1 kN, respectively. The obtained results simply indicate that FSP can be employed to enhance the strength of dual-phase steels with a reasonable level of formability.