Dergi makalesi Açık Erişim

Combustion of Turkish lignites and olive residue: Experiments and kinetic modelling

2017    Magalhaes, Duarte; Kazanc, Feyza; Riaza, Juan; Erensoy, Sevgi; Kabakli, Ozde; Chalmers, Hannah

This study investigated the combustion behavior and kinetics of Turkish fuels. Two lignite coals from Tuncbilek and Soma region, and olive residue, were used, all within a size range of 106-125 mm. Experiments were performed in a thermogravimetric analyzer (TGA) coupled with a differential thermal analyzer (DTA), under three different heating rates, namely 15, 20, and 40 degrees C/min. Based on the weight loss (TG) and derivative weight loss (DTG) curves, the characteristic temperatures were determined, three different conversion stages were identified, and a combustibility index was calculated for the major stage of combustion. In addition, combustion kinetics parameters of each fuel were determined using the Coats-Redfern method. Experimental results revealed that all three fuels went through a decomposition stage followed by the combustion stage(s). Tuncbilek and Soma lignite had one major combustion stage at an approximate peak temperature of 500 degrees C, while olive residue had two distinct stages for combustion at peak temperatures of 290 degrees C and 423 degrees C. Burnout temperatures of olive residue were always lower than either of the lignites, and an increase in heating rate from 20 to 40 degrees C/min shifted the burnout to higher temperatures. Combustibility index of lignites was similar at low heating rates, whereas at higher heating rates the combustibility of Tuncbilek was approximately twice that of Soma lignite. Olive residue presented values of combustibility which were at least fivefold those of the lignites. During the major stage of combustion and at 20 degrees C/min, Tuncbilek lignite had the highest apparent activation energy of approximately 100 kJ/mol, while Soma lignite and olive residue had similar apparent activation energies of approximately 40 kJ/mol. Increasing heating rate clearly increased the reactivity, combustibility, and burnout temperatures of all fuel samples. Apparent activation energies decreased with a shift in the heating rate from 20 to 40 degrees C/min, whereas between 15 and 20 degrees C/min the values were approximately constant. (C) 2017 Elsevier Ltd. All rights reserved.